MAS. M AGNATRON A C S AVER Saves Upto 40% electricity in all ac’s. USP. The World’s most advanced AC saver. The Only programmable AC saver in the world. Dual Sensor & Display for Room & Coil Temperature.
Saves Upto 40% electricity in all ac’s
Energy saving is a function of wasted energy- eventually , therefore , it finally boils down to creating the ability to accurately and continually measuring wastage , under a wide range of constantly changing ambient conditions, and then extract savings , while continually maintaining “THE ROOM TEMPERATURE- AND- SAVINGS EQUATION”
Conventional Air Conditioners have many inherent design deficiencies, which the MAS overcomes IN ORDER TO ACHIEVE THE SAVINGS:
Problem 1 : AC’s have no intelligence and are run ONLY by mechanical relays.
Solution : The MAS adds intelligence with a set of powerful algorithms to your AC to save Energy.
Problem 2: A.C’s have no Room Temperature Sensor but the Temperature sensor is inside the Air Conditioner and hence senses only the Return Air Temperature, thus Energy consumption cannot be optimized, since the Reference Temperature itself is wrong.
Solution : The MAS has an additional digital PROGRAMMABLE sensor for the room to save energy & give you more comfort! This also displays the Room Temp. in real time !
Problem 4 : The AC manufacturer cannot customize the A.C and sells a common control settingdesigned for the hottest conditions, which leads to wastage of electricity.In your A.C when the Set Temp is achieved, the Compressor shuts off for a fixed 3 minutes, and just so you don't feel hot, the manufacturer ensures an Extra Run of 5-6 minutes, i.e. the “over- cooling” period BUT this may be required only for 2-3 hours a day ,at NOON and only 2-3 months in the year. The balance of time ,this "Over-Cooling” WASTES ELECTRICITY.
Solution: In the MAS you can program your “Off-Time” & "Over-Cooling" time based on your climate, day/night use etc. The MAS takes Total Control of your unit and customizes the AC to your climatic conditions.
Problem 5: Many A.C’s typically do not achieve the Room Temp and thus the Compressor does not shut down at all ! While Room Temp does not reduce below a point, the electricity is wasted in only cooling the Coil. Finally , after a point, the condensate on the coil tends to freeze, thus further reducing transfer of the cooling Energy into the room & creating “Thermodynamic Saturation” ,wasting still more Electricity!
Solution : The Coil Sensor in the MAS will cut off the compressor at a Coil Temp. programmed by you.
This 3-Cycle algorithm is based on Time & Room Temperature & this unique combination further enhances savings when there are sharp changes in ambient conditions and adds to the multiple existing 'triggers' to enhance savings.
1.Program your desired Room Temp, Set Temp. and other parameters based on your personal comfort requirements.
2. In the first Cycle (CI) the MAS 1 will “observe and Learn” and only when the Set Temp. Is achieved will It kick Into Cycle 2 (C2), automatically, and not return C1 again, unless restarted from the mains.
3. C2 is a shorter Cycle than C1, but longer than Cycle 3 (C3), (you can reprogram it to a time so your Set Temp. can be achieved) , and when Set Temp. is achieved, it kicks Into C3, but if Set Temp. is not achieved, it will remain In C2, until the Set Temp. is achieved .
4. C3 is a shorter Cycle than C2 (programmed By You) to achieve maximum savings, if Set Temp is reached it will continue In C3, but if it fails to do so, it will revert to C2, the longer Cycle.
5. Hence, hereafter, the compressor will ALTERNATE between Cycle 2 & Cycle 3 to FURTHER ENHANCE SAVINGS.
Buy the lowest cost AC & install the MAS at a fractional cost , to enjoy Higher Energy Efficiency & Superior Pay-Back.