1 / 5

Heating method for unglue end plug from frame

V. Elsha. Heating method for unglue end plug from frame. CERN 07.02.2011. 1. The idea is. to destroy adhesive bond with external heating. See fig.1. Fig.1. This is method for one straw repairing without mechanical damage of the frame hole Others end plug need to keep bonding .

jasia
Download Presentation

Heating method for unglue end plug from frame

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. V. Elsha Heating method for unglue end plug from frame CERN 07.02.2011

  2. 1. The idea is to destroy adhesive bond with external heating. See fig.1 Fig.1 • This is method for one straw repairing without mechanical damage of the frame hole • Others end plug need to keep bonding Argument for • Big temperature gradient in the glue layer. Glue have low thermal conductivity. See fig.2 • Easy to destroy relatively weak bonding. Glue layer have internal tension as a result of free polymerization. Argument against • Long time of the process as result of limitation power of heater. End plugs located side by side. Fig.2 V. Elsha CERN 07.02.2011

  3. 2. The Sample for test • Aluminum plate 150x150x20 mm with 3 glued Al end plugs. The distance between them the same like in prototype. • Bonding joint with glue -Trabond 2115 • Heating with 100W solder equipped with special adapter • Temperature control with thermometer with probe • End plug removing with special remover and screw in the thread of end plug V. Elsha CERN 07.02.2011

  4. 3. The Result Time and temperature for 4points was taken Point 1 – in the center of heated end plug Point 2, 3 – on the plate surface Point 4 - in the center of next end plug After 30 min heating temperature stabilized with 122 C on heated end plug and 54 C on other points. Immediately after heater putting away the end plug was removed with the help of screw. As may be seen from photo the used glue is on surface of hole, but end plug surface is clean V. Elsha CERN 07.02.2011

  5. 4. Conclusion • The method seems to be work • Use it for prototype repairing is possible The next steps Study this method for ultem end plugs V. Elsha CERN 07.02.2011

More Related