1 / 6

sTGC Front end boards NSW Electronics workshop November 2013 L. Levinson Weizmann Institute

sTGC Front end boards NSW Electronics workshop November 2013 L. Levinson Weizmann Institute. sTGC Front end boards. Issues. FE boards on both edges of chamber to balance heat  to avoid cables from side-to-side, need GBT on each edge

grady
Download Presentation

sTGC Front end boards NSW Electronics workshop November 2013 L. Levinson Weizmann Institute

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. sTGCFront end boardsNSW Electronics workshopNovember 2013L. LevinsonWeizmann Institute NSW Electronics workshop, November 2013

  2. sTGC Front end boards NSW Electronics workshop, November 2013

  3. Issues • FE boards on both edges of chamber to balance heat to avoid cables from side-to-side, need GBT on each edge • 2 GBTs per quadruplet instead of GBT per layer cabling is self-contained in one quadruplet loss of one GBT means quadruplet lost MM does GBT per layer for 4 quadruplets • Signal integrity • Zebra connectors, same as for MM • Slow Control Adapter, SCA, ASIC on every FEB for • Configuration of VMM and TDS via I2C • Temperature and voltage monitoring • Calibration of VMM? • E-link connectors from FEB to GBT board: candidate: twinax ribbon • Component height restriction: 9mm DC-DC height? • ?separate analog, digital gnds for VMM NSW Electronics workshop, November 2013

  4. E-links E-link to each Companion, 80Mb/s 6 or 7 per strip FEB, 2 per pad/wire FEB clock  TTC • data (If FELIX streams are used, status/monitoring data can also be sent on this link.) E-link to SCA, 80Mb/s, one per FEB  clock  configuration • configuration reply Can there be single clock pair from GBT? bussed or find a rad tol SLVS fan-out chip NSW Electronics workshop, November 2013

  5. Wire group “FEB” Flex PCB to extract wire signals and bring them to FEB on edge Wires are read out by single VMM per layer on the Pad FEB Wire VMMs need extra protection: transient suppressor Max 64 wire groups per detector NSW Electronics workshop, November 2013

  6. VMM2 board for trigger demonstrator 128 channels Design in progress NSW Electronics workshop, November 2013

More Related