1 / 6

Laser Cutting - Federal Metal Works

Federal Metal Works Co is a prominent metal service provider offer metal cutting service including laser cutting and plasma cutting in turkey.<br>

Download Presentation

Laser Cutting - Federal Metal Works

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Laser Cutting

  2. About Laser Cutting Laser cutting produces part shapes by cutting sheet material using an intense laser beam. This cutting method uses a beam of high-density light energy focused through a tiny hole in a nozzle. 

  3. Materials Several materials are applicable. Aluminum can be laser cut but requires a higher power more expensive laser. Stainless steel, plain steel and spring steel are highly suitable. Metals such as copper alloys are difficult due to their ability to reflect the laser light and absorb heat. Many plastics are problematic due to toxic fumes.

  4. Design Considerations • Sharp inside corners of the part may have a slight • rounding due to beam radius of approximately 0.02 – • 0.04". • Edge burrs are usually minimal and debarring of edges is • usually not necessary. • Thin flimsy structures, such as shapes where a high • percent of material is removed and long slots may • experience some warping.

  5. Advantages The process offers low cost for prototype and short runs since no physical tooling is needed. Heat distortion is minimal and typically limited to about 10% of material thickness. Cut parts generally remain flat. Lasers leave minimal burrs.

  6. For More Information Please Visit: http://federalmetalworks.com/

More Related