1 / 19

A brief introduction about CO2 reforming of methane

A brief introduction about CO2 reforming of methane. Hongyan Ma 2013.05.10. 1.Background. Decreasing in coal and oil reserves A large number of consumption of natural gas Rich reserves in shale gas and coaled methane And the support of policies

fauve
Download Presentation

A brief introduction about CO2 reforming of methane

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. A briefintroduction about CO2 reforming of methane Hongyan Ma 2013.05.10

  2. 1.Background • Decreasing in coal and oil reserves • A large number of consumption of natural gas • Rich reserves in shale gas and coaled methane • And the support of policies • Research about the application of methane

  3. Kazuhiro Takanabe, Journal of the Japan Petroleum Institute, 2012,55(1), 1-12

  4. advantages • Transform natural gas and CO2 into valuable syngas • Give syngas with a lower ratio of H2/CO of approximately 1:1 • Make full use of carbon dioxide in low-grade natural gas resource Mun-sing F. Ahmad Z.A.,ChemCatChem.,2009,1,192-208

  5. 2.Reaction condition Main reaction T=640 ℃ T=550 ℃ Carbon deposition T=700℃ other reaction (RWGS) T=820℃ Influence the ratio of H2/CO

  6. The reaction proceeds at temperatures in excess of 913 K (640℃). • At temperatures in excess of 1093K(820 ℃), the RWGS and Boudouardreactions will not take place. • Formation of carbon most likely takes place within the temperature range 830 K–973, from both the Boudouard reaction and methane decomposition. Mun-sing F. Ahmad Z.A.,ChemCatChem.,2009,1,192-208

  7. Conclusion about conditions • The temperature is important for distribution of products. Finally chose the range of 700-850 ℃. Y. Sun. T. Ritchie,Journalof Natural Gas Chemistry ,2011,20,568–576 Y.H. Li, Y.Q.Wang, International journal of hydrogen energy,2008,33,2507-2514

  8. Pressure: the main reaction is not favorable in higher pressure, so chose ambient pressurein experiment in the laboratory. • CH4/CO2: Although the excess CO2 is helpful for the conversion of CH4 and resistance for carbon deposition, a lots of energy will need to recycle the CO2. So now chose the stoichiometric ratio, namely 1:1.

  9. 3.The reaction process metal active surface(M) prompter (P) acidic support basic support(S) Mun-sing F. Ahmad Z.A.,ChemCatChem.,2009,1,192-208 Anatta W.B.,S.H.Song.CatalSurv Asia,2012,16,183-197

  10. 4.The main challenges • Poisoning • Carbon deposition • Sintering • Solid-state transformation • Metal oxidation Deactivation Pio F., Luca L.,Catalysis Today,1999,52,165-181 Anatta W.B.,S.H.Song.CatalSurv Asia,2012,16,183-197

  11. Carbon deposition and sintering • Effective method • (1) metal: size,morphology,structure The critical size of Ni particles to inhibit coke deposition was suggested to be about 10nm. The surface defects can facilitate carbon formation, like steps and kinks. Beatriz Fidalgo,Chin.J.Catal.,2011,32,207–216 Kazuhiro Takanabe, Journal of the Japan Petroleum Institute, 2012,55(1), 1-12

  12. (2)promoter: enhance the adsorption of CO2 ,enhance the surface reaction, or decrease the rate and degree of methane activation and dissociation • (3)support: well-defined structure like ABO3 or spinels,and form strong interaction with active metal. • (4) others: form solid solutions or alloy with Ni , Co, Fe, Mg,Mnmetal . Chang-jun Liu,ChemCatChem,2011, 3, 529 – 541

  13. 4, the practical method • Form some fine particles in reducing strong Ni-x bond, like Ni-Mg alloy and NiAl2O4. • Form strong interaction in reduction to fixed metal practicles, like Pt-Zr+ in Pt/ZrO2 • Disperse active site (1)using S or B to cover part of site. (2) special structure like spinel (3)some inactive species cover some of site formed in reduction. Like VOxin V2O5 and TiOx in TiO2, MnOx in MnO2. (4) add some promoter to disperse sites • Control the size with special structure-encapsulation Y. H.Hu, E.Ruckenstein ,Adv. Catal. 2004,48,297 – 345

  14. Thank you

More Related