Design, Manufacture, Transport and Integration on-site in Chile of ALMA Antennas
Download
1 / 6

Design, Manufacture, Transport and Integration on-site in Chile of ALMA Antennas MAIN AXES DRIVES - PowerPoint PPT Presentation


  • 109 Views
  • Uploaded on

Design, Manufacture, Transport and Integration on-site in Chile of ALMA Antennas MAIN AXES DRIVES PM#06 18-19 July 2006. Antenna Drives Solution Linear Direct Drives Motors Performances :

loader
I am the owner, or an agent authorized to act on behalf of the owner, of the copyrighted work described.
capcha
Download Presentation

PowerPoint Slideshow about ' Design, Manufacture, Transport and Integration on-site in Chile of ALMA Antennas MAIN AXES DRIVES' - enrico


An Image/Link below is provided (as is) to download presentation

Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author.While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server.


- - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript


  • Antenna Drives Solution Chile of ALMA Antennas

  • Linear Direct Drives

  • Motors Performances:

  • (*) Corresponding “ to drive the antennas to stow in a rainfall rate of 2 cm/hr, with a snow accumulation of 50kg/m2 in the reflector…”

  • (**) Corresponding “ to drive the antennas to stow in a rainfall rate of 2 cm/hr, with a snow accumulation of 41kg/m2 in the reflector…”


  • UPDATE DESIGN LINES

  • Axial room increased up to 320°

  • Increase of sector dimension

  • Reduction of sectors quantity

  • Drive amplifiers on board

  • AC/DC power supply on cabinet

  • Increase of protection degree IP w.r.t. Prototype


  • UPDATE DESIGN LINES

  • Lateral room increased up to 49°

  • Increase of sector dimension

  • Reduction of sectors quantity

  • Drive amplifiers on board

  • AC/DC power supply on cabinet


Main implementations in order to increase torque performances

  • Optimization of wiring (losses reduction)

  • Analysis of possible substitution of PTC sensors system

  • Increase of IP protection degree on AZ axis

  • Optimized electronic solution (Drive on board) with

    • Only DC bus from power supply unit (on switchboard) to sectors

    • Reduction of EMC and harmonics/resonances (possible over-voltages disturbances)

    • Increase availability of system


OPEN POINTS performances

  • Maximum available EL torque

  • Sectors handlings, in particular for EL

  • Erection attachment points on EL axis, under analysis


ad