1 / 7

SANS10400 – X and XA

SANS10400 – X and XA. Neville de Kock 2 June 2011. The Regulation.

deliz
Download Presentation

SANS10400 – X and XA

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. SANS10400 – X and XA Neville de Kock 2 June 2011

  2. The Regulation • At least 50% by volume of the annual average hot water requirement shall be provided by means other than electrical resistance heating, including but not limited to solar heating, heat pumps, heat recovery from other systems or processes

  3. Application • The hot water demand is determined accordance with Table 2 and Table 5 of SANS 10252-1:2004 • The storage requirement is based on maintenance of a hot water temperature of 60 oC • Solar water heating systems shall comply with SANS 1307, SANS 10106 and SANS 10254 based on the thermal performance determined in accordance with the requirements of SANS 6211-1 or SANS 6211-2 • All exposed hot water service pipes shall be clad with insulation with a minimum R-value in accordance with Table 1 • Thermal insulation, if any shall be installed in accordance with the manufacturer’s instructions

  4. Current Heat Pump Requirements • Storage tanks need to comply with SANS 151 • Combined systems where the heat pump is integrated with the tank is covered in SANS 151 • Storage tanks need to comply with the Safety requirements of SANS 60335-2-21 • Heat pumps need to comply with the Safety requirements of SANS 60335-2-40 • There is a need to put together a performance requirement for Heat Pumps

  5. The deemed to satisfy clause • Deemed to satisfy can be achieved either via specifying requirements in a standard or • By a rational design • There is no local performance specification for Heat Pumps, so a simple compliance to a specification cannot be used as a deemed to satisfy, so a rational design is required. • EN 16147:2011 may provide a solution to the performance specification for Heat Pumps

More Related