1 / 3

RO system

RO System.........

Download Presentation

RO system

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Replacing The Pre & Post Filtersh2odropp.com http://h2odropp.com/

  2. Open the spigot to drain all the water out of the storage ank (get a container to save the water). • Place towel under the unit for water spills.  • Use a filter wrench or by hand to open the filter housing, unscrew it from right to left. • Throw away the used filter, and clean the inside of the housing by rinsing it or scrubbing it.  • "Watch for the black "0" ring inside the filter housing (DON’T LOSE IT!).  • Place the new filter inside the filter housing.  • Place the "O" ring in the housing grove (MAKE SURE IT IS IN PLACE)  • Put some Vaseline or silicon-based lubricant on the side of the housing threads.  • Use a filter wrench or by hand to screw the housing back into place by turning it from left to right (Don’t lay down the unit while screw it in, the unit should be stand upright to prevent the O-ring from slipping).  • Repeat the above steps for other filters.  • Observe for any leaks, if there is leak, tighten the housing or re-aligning the O-ring.  • If you are changing a carbon filter or membrane, you must drain the first tank of water after restart the system.  http://h2odropp.com/

  3. http://h2odropp.com/

More Related