1 / 9

Lizard Labs energyAware Commander

Lizard Labs energyAware Commander. EFM32 Training Module. energyAware Commander. Guidelines. Use the standard font sizes No periods in a bulleted list Omit needless words Strunk & White #13 If a bullet goes off the end of the line, reduce the number of words or break into two bullets

cybil
Download Presentation

Lizard Labs energyAware Commander

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Lizard LabsenergyAware Commander EFM32 Training Module

  2. energyAware Commander

  3. Guidelines • Use the standard font sizes • No periods in a bulleted list • Omit needless words • Strunk & White #13 • If a bullet goes off the end of the line, reduce the number of words or break into two bullets • Paragraph spacing for major bullets is 12pt. Don’t put extra lines between bullets • If there are too many bullets to fit on a page, reduce the number of bullets or break into two pages • Use the templates properly. Assign a layout to each page and “reset” it to get to the default font sizes, particularly when importing

  4. Kit Tab

  5. Flash Tab

  6. Files Tab

  7. Demos Tab

  8. Command Line Usage > eACommander.exe -–help energyAwareCommander 2.72 JLink DLL version: 4.54a Availablecommand line switches: --version : Printsversion and exits --help (-h) : Printsthishelpinformation --flash <image.bin> (-f) : Flash binary file to EFM32 --install <package.emz> (-i) : Installkitfirmware --mcuinfo : Print MCU information --kitinfo : Print Kit information --usb <0-3> (-u) : Specify USB address --serialno <serialnumber> : SpecifykitJLinkserialnumber --speed <wanted speed> (-s) : Set SWD speed (in kHz) --swospeed <wanted speed> : Set SWO speed (in Hz) --verify (-v) : Verify flash afterupload --mode <in|out|mcu|off> (-m) : Set debug mode --unlock : Unlock a locked chip --lock (-l) : Lock a chip --reset (-r) : Reset the EFM32 --unprotect : Unprotectpages --protect <start> <stop> : Protectpages --upload <file> : Upload files to DVK --address <address> : Specify flash start address --readswo : Read SWO output (until ENDSWO is encountered in SWO stream) --flashloader <file> : Use a non-standard flashloader --resetkit : Reset kit Note: Commandsareexecuted in the order theyarespecified onthecommand line.

  9. www.silabs.com/mcu

More Related