1 / 6

Straw electronics status

Straw electronics status. Covers. Pre-production 15 boards of each type delivered Vito has tested 6 of each type 6 boards did not pass 1 minor problem with parameters set too tight 0.65A current instead of 0.64A The rest has problems with DAC programming Only read back, writing OK

chiku
Download Presentation

Straw electronics status

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Straw electronics status

  2. Covers • Pre-production • 15 boards of each type delivered • Vito has tested 6 of each type • 6boards did not pass • 1 minor problem with parameters set too tight • 0.65A current instead of 0.64A • The resthas problems with DAC programming • Only read back, writing OK • Firmware checked, timing very tight for read-back • With new firmware (version 9) all boards are OK, yield 100% • The hole for HV connector too tight, 9.8 mm instead of 10mm • Should be fixed for full production • Testing finished • Full production (confusion) • December 2013/Jan 2014

  3. Patch panels • HV • Fully passive now • No DCS • If problem, stop experiment and manual intervention • Modularity changed • 32 channels/chamber to better isolate the problem • 8 channels/view • 4 channels/PP • 2 high precision modules with 16 outputs each • No interlock (?) • Fischer connector with pull lock • Gender • Male on the PP • Female on cable for safety • New product with this arrangement • production 10 weeks • Provisional PP for testing till having final connectors • Equip only 1 input with SHV

  4. Patch panels • LV • The connector on LV module is now only D-SUB 37pin (low current) • 2inputs 8V/10A sufficient in terms of current • Final cover consumption ~0.7A/cover • Save on 2 LV modules/chamber • Possibility to improve current measurement • Special chip for measuring current on ‘high’ side • Both PP should go to the production as soon as we know for sure • Type of the connectors • Cable types • Mechanical constraints – mounting, (dis-)assembly, etc • Simple objects – production fast

  5. Cables • Ethernet/data cables • Need to define the length • How many different? • Wait for the 1st chamber installed and measure the legth • February 2014 • HV • HV now standard 5kV coax • SHV on crate side, Fischer on PP side • No interlock • Production at CERN • LV • Harness needed from D-SUB connector • Cable cross-section to PP smaller, ~4mm2 for ~1V drop • Shield?

  6. SRB • The first FPGAs received • Model with 2 core CPU in December • Definition of components, protocols • “CPU or not CPU” for data to pc-farm • Firmware more performant but also more difficult to write, change, maintain • C-code easier to write, debug, change • Prototype January?

More Related