1 / 12

Silicon sensors status

Silicon sensors status. Václav Vrba Institute of Physics , AS CR, Prague. Pad array design consideration. Along with the diodes, the technique used for fabrication of bias resistors and coupling capacitors represents an important issue:

Download Presentation

Silicon sensors status

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Silicon sensors status Václav Vrba Institute of Physics, AS CR, Prague Václav Vrba, Institute of Physics, AS CR

  2. Pad array design consideration Along with the diodes, the technique used for fabrication of bias resistors and coupling capacitors represents an important issue: a) polysilicon resistors – production of the tile needs about 7-8 masks; can be the source of additional yield reduction. b) punch through resistors – production of the tile needs about 5 masks; easy to produce – needs to check whether required parameters can be achieved. c) ion implantation resistors – not considered here. Václav Vrba, Institute of Physics, AS CR

  3. Design consideration: Polysilicon resistors Bias lines Top view Direct contact on diode – e.g. for testing Bias resistor Coupling capacitor Vertical cross section Václav Vrba, Institute of Physics, AS CR

  4. Design consideration: Polysilicon resistors Václav Vrba, Institute of Physics, AS CR

  5. Design consideration: Punch through resistors Bias lines Top view Direct contact on diode – e.g. for testing Bias resistor Coupling capacitor Vertical cross section Václav Vrba, Institute of Physics, AS CR

  6. Design consideration: a partial summary a) polysilicon resistors: • should not be a problem to have resistors  10 M; • capacitors  1-10 nF. b) punch through resistors: • resistors to be tested; if acceptable then it is a simple solution; • capacitors as a). Compatibility of process for variants a)andb) on one wafer? Option a) as a baseline for main sensor tile? Václav Vrba, Institute of Physics, AS CR

  7. Pre-prototyping Václav Vrba, Institute of Physics, AS CR

  8. Tests outlines A) Diode tests a) I-V curves: • Vbreak-down Vop • Ileak @ Vop < cca 30 nA/cm2 b) C-V curves: • determination of Vfull-depletion; Vop = Vfull-depletion + 50 V. c) Long term stability tests: • Ileak @ Vop . Tile should be rejected if: • Vbreak-down< Vop • Ileak > I crit (to be defined). Václav Vrba, Institute of Physics, AS CR

  9. Electric characterization Václav Vrba, Institute of Physics, AS CR

  10. Tests outlines B) Bias resistors a) shorts b) breaks c) outside specifications C) Capacitance couplings a) shorts b) breaks c) outside specifications Václav Vrba, Institute of Physics, AS CR

  11. Tests outlines Basic equipment: • micromanipulators with contact needles; • I-V: Keithley 487 A; • C-V: LCR meter HP Václav Vrba, Institute of Physics, AS CR

  12. Probestation Václav Vrba, Institute of Physics, AS CR

More Related