1 / 4

Current Works

Current Works. Performed A/D conversion on all 4 XBee pins Implemented voltage dividers for input from IMU Discovered Op-Amp Buffer required and re-implemented circuit Successfully reading input from IMU wirelessly! Continued MATLAB implementation of parse code

binta
Download Presentation

Current Works

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Current Works • Performed A/D conversion on all 4 XBee pins • Implemented voltage dividers for input from IMU • Discovered Op-Amp Buffer required and re-implemented circuit • Successfully reading input from IMU wirelessly! • Continued MATLAB implementation of parse code • Seems to parse correctly but seems to miss packets • Created LabVIEW implementation of parse code • Successfully reads voltages from all 3 sensors for planar motion and displays on graph • Noticed that occasionally frame size varies or packet is lost and voltage is recorded as 0 volts • Will look into why this occurs • Sample rate does not seem to be as low as set by the parameter (sample ever millisecond), see included table • Performed more research for second version (next slide)

  2. Next Version • Best solution seems to be: • http://www.sparkfun.com/commerce/product_info.php?products_id=9184 • 6 Degrees of freedom IMU • XBEE mount built in • ATMEL ATMEGA microprocessor built in • Downsides • Uses Lithium polymer battery that will need to be purchased along with recharger • AVR Programmer not included but Microprocessor looks to preprogrammed and supplied code should be sufficient (will email company to verify)

  3. What’s Next? • Continue LabVIEW implementation • Figure out why random zero values, calibration, saving to a file • Email XBEE manufacturer about sample rate problem • Continue MATLAB implementation • Begin researching calibration techniques • Order parts for final version

More Related