1 / 14

Facilities Management and Design

Facilities Management and Design. Chapter 7 HVAC Systems. Thermal Comfort. Balancing heat produced by one’s body with surrounding environment. Body heat lost by convection, radiation, and evaporation. Factors that influence comfort. indoor temperature humidity air movement

baylee
Download Presentation

Facilities Management and Design

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Facilities Management and Design Chapter 7 HVAC Systems

  2. Thermal Comfort • Balancing heat produced by one’s body with surrounding environment. • Body heat lost by convection, radiation, and evaporation

  3. Factors that influence comfort • indoor temperature • humidity • air movement • room surface temperatures • overall air quality

  4. Comfort zone • Insert comfort zone chart

  5. Heat sources • Electricity– Used in all electric heaters. Requires no flue. Usually most expensive. • Natural gas – Clean burning. Flue required. Very efficient. Delivered via underground pipe • Liquefied petroleum – relatively clean burning. Requires on-site storage tank. Delivered via truck. • Fuel oil – tendency to create dirt/smoke. Requires on-site storage tank. Delivered via truck. Various grades available. • Steam – more common in urban areas where available from local utility or in large complexes with central steam plant. Supply and return lines required.

  6. Heating equipment • Furnaces and Boilers • Combustion efficiency Flue Furnace Heat Exchanger

  7. Cooling Systems • Boyles Ideal Gas Law • Pressure • Temperature • Volume • Certain gases react more actively • Refrigerants • CFC’s • HCFC’s

  8. The Refrigeration Cycle Compressor Evaporator Coil Condenser Coil Expansion Valve/ Metering Device

  9. Cooling system operating and maintenance concerns • Types of compressors • Reciprocating • Centrifugal • Rotary • Energy efficiency ratio (EER) • Integrated part load values (IPLV) • Environmental Protection Agency • supervises aspects of refrigeration equipment maintenance • importance of eliminating or reducing refrigerant leaks

  10. Cooling system operating and maintenance concerns • Types of compressors • Reciprocating • Centrifugal • Rotary • Energy efficiency ratio (EER) • Integrated part load values (IPLV) • Environmental Protection Agency • supervises aspects of refrigeration equipment maintenance • importance of eliminating or reducing refrigerant leaks

  11. HVAC system types • Centralized systems; quiet • two-pipe • three-pipe • four-pipe • Decentralized systems; not as quiet • heating and cooling sources in guestroom itself or along outside wall • Hybrid systems • characteristics of centralized and decentralized systems

  12. System types and maintenance needs of HVAC systems for other building areas • Air handling units • Isolation of zones (housekeeping, kitchen, maintenance…) • Packaged air conditioning units • usually mounted on roof • Maintenance issues • Filter replacement • belt checking and replacement • cleaning of fans and heat transfer surfaces

  13. HVAC controls • Today’s controls are often electronic • Thermostat • enthalpy or economizer control • Older control sensors—mechanical sensing • Digital control systems • variable air volume (VAV) systems • load sensing equipment • EMS sensors

  14. Cooling towers • Startup and shutdown concerns • Inspection and lubrication of pumps and fans • Removal of dirt and other debris • Treatments to reduce bacteria, scale, and corrosion • Inspection of metal surfaces

More Related