How to Do Boat Maintenance on a Budget

1. How to Do Boat Maintenance on a Budget

2. Introduction Maintaining a budget is hard enough these days let alone keeping up with everything. The recent economic downturn has caused many boat owners to learn how to perform their maintenance as well as shop for more budget-friendly products. Common repairs can be done on a tight budget with little knowledge.

3. How to Start Not possibly go through all the repairs of an inboard or outboard motor but a few of them are common to anyone. To start with if you own an outboard motor, the fuel system may contain the older carburetors. These motors will soon experience carburetor problems if not already. The service shops and marinas typically perform carburetor repairs on an ongoing basis. The process can be simple if you have some good mechanical aptitude and a little patience. Most carburetor repairs consist of mainly a good cleaning and replacement of any worn parts. Typically, the parts replaced will be any gaskets encountered and also what is called a needle and seat.

4. Problems Any carburetor can have many of these and the problems associated with almost all outboard motor carburetors are simply clogged jets. The needle and seat maintain the correct amount of fuel in the bowl of the carburetor allowing it to operate. The needle closes the incoming fuel as the float pushes it against the seat creating a liquid-tight seal. Remember, all of these parts should be replaced during the process. Another completely unavoidable item is the water pump impeller. The impeller will need to be replaced at a minimum once per season. While many let them remain longer it is dangerous as the entire cooling system will fail if it cannot get water which depends on that little pump's impeller. The impellers have what is called Veins which are the fingers so to speak that create the star pattern look. Those veins break down over time and can even wear out too soon if boating in shallow areas as debris and sand enter the cooling system.

5. Outboard motor On an outboard motor, the impeller is located at the top of the gearbox assembly and is driven by the drive shaft. The same holds for most inboard engines as outdrive contains the impeller with` a similar location. Keep in mind some inboard applications use the water intake by driving straight off the engine under the deck and not on an outdrive. These applications use what is called a raw water pump but still operate in a similar way utilizing an intake port through the bottom of the boat hull. Among all of these, the impeller should be replaced along with any gaskets or other hardware necessary. Some will even have replacement pump housings or inserts which will need to be replaced if necessary after inspection.

6. Conclusion So now the hard part with the purchases as we try to make purchases without breaking the bank. The budget and cost associated with boat parts are unusually high. It seems anything manufactured specifically for marine applications can be very costly and sometimes hard to understand. Although many boat parts are only available in OEM applications usually any items just for maintenance are available for aftermarket. Purchasing online is probably the best alternative as long as the correct parts are purchased. Even on a budget standard maintenance can be done on almost any boat. If completing a repair always consider purchasing any parts ahead of time online to keep the repairs easy on your wallet.