1 / 6

How to setup a snare

How to setup a snare. Instructions . 1 . Cut a 4-inch limb to length with a knife. Trim smaller branches from the limb with a knife and cut the limb to a length of 8-feet. I nstructions.

ankti
Download Presentation

How to setup a snare

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. How to setup a snare

  2. Instructions 1. Cut a 4-inch limb to length with a knife. Trim smaller branches from the limb with a knife and cut the limb to a length of 8-feet.

  3. Instructions 2. Place the limb against a tree trunk at a 45-degree angle. Choose a tree such as an oak or beechnut in a location where squirrels are active. Watch the area to determine frequently traveled paths to the tree.

  4. instruction 3. Unroll a length of snare wire with a formed loop on one end and a straight end on the other. Wrap the straight end around the limb. Twist the free end around the main snare wire length to securely attach the wire around the limb. Form the twist at the bottom of the limb.

  5. Instruction 4. Bend the snare wire around the side of the limb. Open the loop on the snare wire so it is at least 5-inches across.

  6. Instruction 5. Position the bottom of the loop no more than 2-inches above the limb. Place a small amount of bait such as peanut butter to either side of the limb as bait.

More Related