Download
1 / 26

Installing a single Dreamscreen - PowerPoint PPT Presentation


  • 179 Views
  • Uploaded on

Installing a single Dreamscreen. Set unit in place and attach with 2 ½ “ screw. Do not tighten the screw yet, tighten just enough to keep from falling. Insert silver track clip into the jamb. It fits between the magnet and the jamb. Put one at each end.

loader
I am the owner, or an agent authorized to act on behalf of the owner, of the copyrighted work described.
capcha
Download Presentation

PowerPoint Slideshow about ' Installing a single Dreamscreen' - anka


An Image/Link below is provided (as is) to download presentation

Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author.While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server.


- - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript

Set unit in place and attach with 2 ½ “ screw.

Do not tighten the screw yet, tighten just enough to keep from falling.


Insert silver track clip into the jamb it fits between the magnet and the jamb put one at each end
Insert silver track clip into the jamb. It fits between the magnet and the jamb.Put one at each end.


Stand the jamb upright on opposite side attach with one screw
Stand the jamb upright on opposite side, attach with one screw.

  • There are 5 screw holes in the jamb.

    Put a screw in the middle hole only to start. This way if you have to move the jamb, you only have to patch one hole.



Make sure the measurement is the same top and bottom
Make sure the measurement is the same top and bottom screw.

Add 1/8” to this measurement

Housing

Jamb



Prepare your tracks
Prepare your tracks screw.

Notice the stickers


Prepare your tracks1
Prepare your tracks screw.

Notice the stickers




Make the cut
Make the cut screw.

Cut both tracks together to make them the same size





Fit onto clip on the jamb side
Fit onto clip on the jamb side screw.

You may need to remove that single screw for this.




Flush to the housing
Flush to the housing screw.

Bottom screw, not yet tight


Fit jamb side same as the top make sure track reaches magnet
Fit jamb side same as the top screw.make sure track reaches magnet


Make sure unit is square make adjustment if necessary
Make sure unit is square! screw.Make adjustment if necessary

Once it’s squared, tighten bottom and top screw.



Lubricate the tracks simply spray where the plastic meets the metal
Lubricate the tracks screw.simply spray where the plastic meets the metal

Use pure clear silicone spray…..never use WD-40




ad