1 / 18

PNWQRP USB Radio Interface Project

PNWQRP USB Radio Interface Project. Lyle Johnson, KK7P 11 July 2010 Salmoncon V. Background. Softrock Ensemble Receiver Group SDR Exposure Requires PC w/Soundcard Soundcard Must Support Stereo Input I and Q Signals for Subsequent Processing I and Q? Think “Phasing SSB”

Albert_Lan
Download Presentation

PNWQRP USB Radio Interface Project

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. PNWQRP USB Radio Interface Project Lyle Johnson, KK7P 11 July 2010 Salmoncon V

  2. Background • Softrock Ensemble Receiver • Group SDR Exposure • Requires PC w/Soundcard • Soundcard Must Support Stereo Input • I and Q Signals for Subsequent Processing • I and Q? Think “Phasing SSB” • Most Laptops have Mono Input • Microphone • For Web Chats, Apparently

  3. Ensemble Overview • Full HF Band Coverage 160m – 10m • Uses Si570 Local Oscillator • Wide Range • Very Clean (Low Phase Noise) • USB Based • Free Software • Rocky • Kit less than $60

  4. Ensemble Soundcard Requirements • Low Noise • Sets Receiver Noise Floor • High Gain • Dealing with Microvolt Signals • Reasonable Dynamic Range • Could Definitely Use Preamp/Multi-Attenuator • Volunteers? • USB Interface • Not Required, but Convenient

  5. TI USB Audio • PCM2900 Family • USB 1.1 (2.0 Compatible) • 48 kHz Sampling Rate • Limits Spectrum Display to +/- 24 kHz • Meets USB Audio Spec • Recognized by Windows XP and Later • No special drivers needed • Stereo In/Out • Might Want Tx Later 

  6. USBRI Evolution • Soundcard Only • Cheap and Simple • USB Hub • Replace USB Port Consumed by Soundcard • Need a USB Port for Ensemble Control • Serial Port • Always Seem to Need (at least) One More • Radio Interface (C.A.T., Etc.)

  7. Radio Interface • Radio Control (aka C.A.T.) • Icom CI-V • RS232 (Various brands) • Async not RS232 (some Yaesu, Kenwood ) • PTT • CW Keying • FSK

  8. Radio Interface Standards • Standards? Dream on… • Think ”8-pin Foster Mic Connector” • Looked at RigExpert, MicroHam, Others • RE and US Interface • Same DB-25 Pinout • Readily Available Connectors • Must Be a Standard!!! • Adopted RE as Standard

  9. Other Features • FSK • USB <-> Async Don’t Do 45.45 bps 5 Level • Didn’t Want to Make My Own • But Happy If You Contribute! • Pseudo FSK from FL Digi • DTR from MMTTY DLL • Jumper Selection • Ugh!

  10. Other Features • CW • DTR • Shared with MMTTY DLL for FSK • K1EL Winkey 2.0 (June P&C) • Note: The following Winkey features not planned… • Paddle Input • Speed Pot • Message Buttons • … as this is a USB-powered computer interface. • All • RTS for PTT Function

  11. Development • Project Proposed May 2010 P&C • Prototype Built by June 2010 P&C • Prototype Problems • USB Expansion Port Dead • Spare RS232 Port Dead • Prototype Successes • Audio • CAT (RS232 to K3) Using Commercial Cable

  12. Prototype USBRI

  13. Future Work 1 • Add Winkey 2.0 Support • Change Internal Dual RS232 to Quad? • Spare Serial • C.A.T. • Winkey (otherwise Jumper Select) • Dedicated DTR/RTS (now p/o C.A.T. port) • Possibly add PIC for Configuration • Eliminate Jumpers!

  14. Future Work 2 • Design Update on Serial Port • Schematic and PCB Done • Finish Test/Debug of Existing Features • Isolation on Serial Port? • Isolation on C.A.T. Port? • New Prototype • Release for Ordering and Kitting

  15. Possible USBRI

  16. USB RI • Should be Under $100 Including Case • You Mark, Drill and Label Panels! • Any Volunteers to Arrange Punched/Screened? • RE Standard is ~$215 • MicroKeyer USBIII is ~$199 • US Interface is ~$369 • Larger Case Could Include Ensemble • EMI/RFI Issues? • Hope to Have 2nd Prototype Late August

  17. Conclusion • Provides Consistent Way to Explore SDR • Useful Shack Accessory for Any Radio • Well, Almost Any Radio 

  18. USB RI THANK YOU

More Related